Published at Sunday, 02 September 2018. Nailer. By Amy Mccall.
In contrast to the pneumatic nailers, Coil type nailers use coils or springs to shoot in the mails. For construction projects that require workers to use nailers for extended periods of time, these nailers are used. They are designed to hold a large number of nails at a point of time and are designed such that they do not tire out the workers easily.
When you're using the finish nailer, have the tip positioned on to the trim board where you want to have the nail driven. Then, carefully adjust its position so that you'll drive the nail in the right direction. Usually, when the finish nailer's cylinder and its tip line up perpendicularly to the board's face, it gets your nail driven squarely in the board. In some cases however, you need to adjust the nail's angle so you can capture enough wood behind the molding or trim you're using.
When you work on a finish nailer, you need the head to be just below the board's surface so it can be filled easily with the nail filler. If your nails haven't been sunk completely, you can use a hammer and a nail set to drive them in completely (although, this is extra work which you shouldn't have to do if you do things right). The problem which you usually get is caused by either an insufficient amount of pressure from the compressor, or the depth on the adjustment dial which wasn't set correctly. If you're not sure with the settings you need to use, consult your operating manual and follow the instructions on how to correctly modify the depth adjustment.
Any content, trademark’s, or other material that might be found on the etinet.biz website that is not etinet.biz’s property remains the copyright of its respective owner/s. In no way does etinet.biz claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 etinet.biz. All Rights Reserved.