Published at Sunday, 02 September 2018. Nailer. By Liz Harrell.
Air nailers are needed frequently in the house but unfortunately an all-purpose air nailer that can be used for multiple purposes is not usually available. There is a specific air nailer required for each construction product and very few air nailers can be used for multiple projects. There are separate nailers available that are used for working with thinner wood materials, but the same nailers cannot be used for projects using thicker wood slabs. A few of the air nailers available in the market have been discussed below:
On another hand, Porter-Cable's BN200B is another (18 gauge) brad nailer with all the power and innovation to bring you impressive results with every single shot. With a long-lasting, virtually maintenance-free motor, the tool's durable high-performance is unfailingly reliable, and with a rear exhaust keeping oils and contaminants away from your workpieces, your results are clean and precise. Additionally, a (removable) no-marring nose piece keeps your materials protected against scrapes and scuffs for for the cleanest possible results. The BN200B drives nails from 5/8" to 2" in length (with a depth-of-drive adjustment), and because of an internal piston catch, the tool delivers consistent max power through every shot. A low nail reload mechanism indicates when a reload is required, and with a tool-free jam release, nail removal is always simple. The tool has a 100 nail magazine capacity, and weighing only 2.6 lbs the tool is comfortable during continuous use and even the most awkward applications. Although its strikingly lightweight, the tool is also built with a strong die-cast aluminum body for long-lasting durability, and a special hardened driver blade additionally contributes to the tool's overall longevity. Ultimately, this nailer is pretty awesome, and pricing at only around $100, its a superior tool that will also fit into your budget.
When you're using the finish nailer, have the tip positioned on to the trim board where you want to have the nail driven. Then, carefully adjust its position so that you'll drive the nail in the right direction. Usually, when the finish nailer's cylinder and its tip line up perpendicularly to the board's face, it gets your nail driven squarely in the board. In some cases however, you need to adjust the nail's angle so you can capture enough wood behind the molding or trim you're using.
Any content, trademark’s, or other material that might be found on the etinet.biz website that is not etinet.biz’s property remains the copyright of its respective owner/s. In no way does etinet.biz claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 etinet.biz. All Rights Reserved.